Cleaning The Filters - Sharp AE-X127J Operation Manual

Use this mode when the remote control is not available.
Lift the front panel of the indoor unit and press the AUX.
button on the operation panel.
The red OPERATION lamp on the indoor unit will light up
l
and the unit will start operating in the AUTO mode.
The fan speed and temperature setting will be set to AUTO.
l
TO TURN OFF
Press the AUX. button on the operation panel again.
The red OPERATION lamp on the indoor unit will go out.
l
NOTE:
If the AUX. button is pressed during normal operation, the
unit will turn off.
Be sure to unplug the power cord from the wall outlet or turn off the circuit breaker
before performing any maintenance.

CLEANING THE FILTERS

The air filters should be cleaned every two weeks.
TURN OFF THE UNIT
1
REMOVE THE FILTERS
1 Lift up the front panel of the indoor unit.
2 Push the air filters up slightly to unlock them.
3 Pull the air filters down to remove them.
CLEAN THE FILTERS
Use a vacuum cleaner to remove the dust. If the
filters are dirty, wash them with warm water and a
mild detergent. Dry the filters in the shade before
reinstalling.
REINSTALL THE FILTERS
1 Reinstall the filters.
2 Close the front panel.
3 Push the centre of the front panel firmly to lock it
in place.
12