Sharp AE-X127J Operation Manual page 29

To recall a memorised station:
Press the PRESET (V or ) button for less than 0.5
A
seconds to select the desired station.
and frequency band) which have been stored in
memory will appear in the display in numerical order,
irrespective of the frequency bands.
Note:
When searching for a memorised station, do not press
the PRESET button for more than 0.5 seconds,
When the PRESET button is pressed for more than 0.5
seconds, the unit will enter the preset memory scan
mode.
Backup function:
The backup function protects all station presets for a
few hours should there be a power failure or the AC
power lead is removed from the AC socket.
6
n
Preset memory scan
The stations saved in the preset memory can be scanned auto-
matically.
1
To scan the preset stations, press the PRESET (V or
button for more than 0.5 seconds.
are sequentially received for 5 seconds each.
2
Press the PRESET (V or
scan at the desired station.
Note:
When the preset memory does not have any stations stored in
it, the preset memory scan will not function.
Set the ON/STAND-BY switch to ON.
2
Press the TAPE (l-2) button.
3
Open the cassette door by pushing the area marked "PUSH
EJECT".
4
Load the cassette into the TAPE 1 or TAPE 2 cassette com-
partment.
5
With cassettes in both decks, press the TAPE (I-2) button
to switch operation from one deck to the other.
6
Press the F/c (p) button to start playback.
When playback is performed using the remote control, press
the TAPE 1 or TAPE 2 ) button.
To stop playback:
Press the n button.
Fast forward/rewind: (TAPE 2 only)
1
Press the n
select TAPE 2.
To rewind it, press the 44 button.
Precautions:
6
then open the cassette compartment.
l Before changing from one tape operation to another, press
2 5 9
the H button.
will remain engaged with the tape and the cassette door will
not open. In this case, wait until power is restored.
) button again to stop the memory
A
button, then press the TAPE (l-2) button to
)
A