Sharp AE-X127J Operation Manual page 25

Cautions:
Do not carry the unit with discs left in the disc
trays. The discs may come loose inside the unit
and be damaged or cause damage to the unit.
This may also cause malfunctions.
Do not place two CDs in one disc position.
Do not push the disc tray whilst it is moving.
Do not attempt to turn the disc tray by hand. This
may cause malfunctions.
If power fails whilst the tray is open, wait until the
power supply returns or gently push the tray ma-
nually to close it.
If the disc tray is stopped forcibly, "ERROR" will ap-
pear on the display and the unit will not function.
If this occurs, turn off the ON/STAND-BY switch and
turn it on again.
If TV or radio interference occurs during CD oper-
ation, move the unit away from the TV or radio.
If a disc is damaged, dirty, or loaded upside down,
the disc will be skipped and the next disc will be
automatically played.
n
Loading and playing CDs
1
12 cm (5")
Set the ON/STAND-BY switch to ON.
Press the CD button.
3
Press the OPEN/CLOSE button to open the disc tray.
4
Place the CD(s) on the disc tray, label side up.
CDs can be placed on any open position on the disc tray.
Be sure to place 8 cm (3") CD(s) in the middle of the disc
trays.
Caution:
Do not stack CDs in the tray.
This can damage the player and the CDs.
5
When loading a third disc, press the DISC SKIP button to
3 6 I I
turn the disc tray, then place the CD in the open position.
6
5
Press the OPEN/CLOSE button to close the disc tray.
a
The total number of tracks and the total playing time for one
disc will be displayed. At this time, the disc number indicator
is flashing.
Press the desired disc number button ( @ 1 - @ 3).
5
Press the ) /c button.
8
Playback will begin from track 1 on the disc you have speci-
fied to play.
After the disc finishes playing, the next disc will be automat-
ically played.
When there is no CD in one of the disc 1 - 3 positions, that
position will be skipped and the next CD will be played.
When the last track on the third disc has finished playing, the
unit will stop automatically.
To interrupt playback:
1
Press the CD II button on the remote control.
'II"
will appear.
2
Press the F c button to resume*playback from the same
point.
To stop playback:
Press the n (CD
To remove the CDs:
Whilst in the stop mode, press the OPEN/CLOSE button.
the DISC SKIP button to rotate the disc tray and remove the
remaining disc.
To switch the unit off after use:
Set the ON/STAND-BY switch to STAND-BY.
8
n
) button.