Using Emp Monitor; Opening And Closing Emp Monitor - Epson PowerLite 6110i User Manual

note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Network On in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).
Monitoring the Projector Over a Network
78
■
Address 1/2/3 Setting
Choose one of the
e-mail address where you want to receive a message when a
problem occurs.
4. When you're done, press
When a problem occurs, an e-mail message is sent to the specified
addresses with the subject line
information:
Line 1: The name of the projector where the problem has
■
occurred
Line 2: The IP address of the projector where the problem has
■
occurred
Line 3: Details of the problem
■

Using EMP Monitor

EMP Monitor lets you use a remote computer to manage your
projectors. It lets you easily turn them on or off (together or
individually), switch image sources, and check on their status.
Before using EMP Monitor, make sure you've installed the software
(available for Windows only) as described on page 74. The computer
you're using to monitor the projector should already be connected to
your network.

Opening and Closing EMP Monitor

To start EMP Monitor, click
EPSON Projector > EMP Monitor
fields, then enter the
Address Setting
to exit the menu system.
Menu
EPSON Projector
or
Start > Programs
.
and the following
All Programs >