Epson PowerLite 6110i User Manual page 59

■
Operation Lock
In mode, disables all of the projector's buttons,
Full Lock
including the P Power button. In
disables all of the projector's buttons except the P Power
button. Changes to this setting take effect after you restart the
projector. (After you turn off the projector, wait for the
P Power light to turn solid orange before turning it
on again.)
■
Pointer Shape
Lets you select from three different pointer shapes. The
Password Protect function must be cancelled first. See
page 70.
■
Brightness Control
Allows you to select
projection is too bright for the room. The Low setting also
reduces electricity consumption and fan noise. Select
to project at the maximum brightness. (Also check the
Brightness setting in the Image menu; see page 55.)
■
Volume
Adjusts the volume for the projector's speaker or an audio
system connected to the projector.
■
RCA Audio Input
Lets you change the
the Video port or S-Video port. Select
port for the Video port. Select
for the S-Video port.
■ Remote Receiver
Select to disable the remote control receivers on the
Off
projector to prevent interference from fluorescent lighting or
other sources. Or enable specific receivers using the following
settings:
Front/Rear
■
Test Pattern
Allows you to adjust the projector without a video source.
While the test pattern is displayed, you can make Zoom,
Focus, and Keystone adjustments.
3. When you're finished, press
Partial Lock
lamp brightness when the
Low
audio port as the input for
L-Audio-R
Video
to use the RCA port
S-Video
, , or .
Front Rear
or .
Esc Menu
mode,
note
To cancel the Operation
Lock function from the
projector, press the
button for about seven
seconds.
High
to use the RCA
Configuring the Projector
Enter
59