Replacing The Lamp - Epson PowerLite 6110i User Manual

Replacing the Lamp

The projection lamp typically lasts about 4000 hours. It is time to
replace the lamp when:
The projected image gets darker or starts to deteriorate.
■
■ The message
Replace the Lamp
the lamp comes on and the lamp warning light
To maintain projector brightness and image quality, replace the
lamp as soon as possible.
■ The lamp warning light
Contact your dealer or contact an Epson authorized reseller for a
replacement lamp. Request part number
nearest reseller, call 800-GO-EPSON (800-463-7766). Or you can
purchase online at www.epsonstore.com (U.S. sales) or www.epson.ca
(Canadian sales).
Follow these steps to replace the lamp:
1. Turn off the projector.
2. When the P Power light stops flashing, unplug the power cord.
3. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
4. To release the lamp cover, insert the screwdriver included with the
new lamp as shown, then remove the cover.
appears on the screen and when
flashes orange.
flashes red (the lamp is burnt out).
. To find the
V13H010L45
note
Turn off the projector when
not in use to prolong the life
of the projector lamp.
You can check how long the
lamp has been in use (see
page 91).
Lamp life results will vary
depending upon mode
selected, environmental
conditions and usage.
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury.
Maintaining the Projector
89