Epson PowerLite 6110i User Manual page 96

Light Status
Green
Flashing orange
Green
Orange
Green
Flashing orange
Red
Flashing red
Red
Red
Solving Problems
96
Description
It's time to replace the lamp. See page 89 for instructions. If you continue
to use the lamp after the replacement warning, there is an increased
possibility that the lamp may break.
No air filter. Make sure that the air filter is securely installed; see page 87.
If the error continues when the air filter is installed, there is a problem
with the air filter sensor. Stop using the projector, disconnect the power
cord, and contact Epson as described on page 106.
Low air flow. If you see a message saying that the air filter is clogged,
make sure that the air filter is clean. If it is clogged, clean it or replace it
with a new filter; see page 87.
There is a problem with the fan or temperature sensor. Stop using the
projector, disconnect the power cable, and contact Epson as described
on page 106.
The projector is overheating, which turns the lamp off automatically. Wait
until the cooling fan stops, about five minutes, then unplug the power
cord. Plug the power cord back in and press the P Power button. Make
sure the room temperature is not above 95 °F (35 °C) and there is plenty
of space around and under the projector for ventilation.
The air filter may be clogged. Clean or replace it as described on page 87.
If the projector continues to overheat after you clean the air filter, the
problem may be caused by damage to the cooling fan or temperature
sensor. Contact Epson for help.
Warning: Except as specifically explained in this User's Guide, do not
attempt to service this product yourself.
If you installed the optional Epson smoke filter in the projector, try the
following:
■
If you are using the projector at a high altitude (4,900 feet [1500
meters] or higher), set High Altitude Mode to On (see page 61).
■
You may need to set the Brightness Control to Low (see page 59).
■
Replace the smoke filter (see page 87).
If the error continues, stop using the projector, disconnect the power
cable from the electrical outlet, and contact Epson as described on
page 106.