Using With The Alkaline Battery; Inserting A Minidisc - Sharp MD-MT200H Operation Manual

Using with the Alkaline Battery

Use one commercially available alkaline battery (LR6,
"AA" size).
Open
2
Press
1
RELEASE
When using the alkaline battery, be sure to insert the
rechargeable battery also.
1
Open the case cover.

Inserting a MiniDisc

When you record on a MiniDisc, check
that the erase prevention tab is set to the
Recordable Recording
"Recordable" position.
prevented
1
Slide the OPEN lever to release the compartment
door.
2
Insert an alkaline battery into the battery case.
3
Attach the battery case to the portable MD.
Back of the
portable MD
Caution:


Whilst you are using the rechargeable battery and the
alkaline battery at the same time, do not remove either of
them. If you do, when the unit is in the play mode, play-
back will stop. When in the recording mode, the recorded
contents will be erased, and the power may be discon-
LOCK
nected.


Do not replace the battery or the rechargeable battery
during operation.


Do not use a rechargeable battery (nickel-cadmium
battery etc.) in the battery case.


If the unit is not used for a long period of time, remove the
battery. (Even if the power is turned off, the battery will be
drained slowly but continuously.)
2
Lift it up.
3
Insert a MiniDisc as shown.
4
Close the compartment door.
Notes:


Do not place the MiniDisc under the holder.


If any resistance is felt, do not force the MiniDisc into the
unit, as it may cause damage to the unit. If resistance is
felt, remove the MiniDisc and reload it.


The lid cannot be opened if "TOC" is displayed; refer to
the instruction on page 13.
01/11/27 MD-MT200H(SEEG)_E_2.fm
MD-MT200H
ENGLISH
E-8