Operation Manual; Battery Power - Sharp MD-SR60 Service Manual

MD-SR60

Battery Power

1 2
5
To an AC
outlet
AC 120V,
60 Hz

OPERATION MANUAL

3
4
1
2
6
5
To the DC
IN 5V jack
– 4 –
Charging the rechargeable battery
When the rechargeable battery is used for the first
time or when you use it after a long period of dis-
use, be sure to charge it fully.
1
Slide the battery cover as far as it will go
to the outside.
2
Lift the battery cover.
Do not force the battery cover open too far.
3
Insert the rechargeable battery from the
(+) marked side.
Only the rechargeable battery that is supplied
and the battery that is available separately
(Part number AD-N70BT) can be charged.
4
Close the battery cover.
5
Plug the AC adaptor into the AC outlet, and
then insert the plug on the other end into
the DC IN 5V jack.
6
Press the :OFF/CHRG (• ) button.
" " will flash, and battery will begin charging.
Checking the remaining amount of
battery level
The remaining amount of battery level is shown
by the battery indicator (
How to read the battery indicator
When the battery
level is high
When the battery is completely discharged, the battery
indicator will flash. Recharge the battery or replace the
alkaline battery with a new one.
When the battery has run completely out, "BATT
EMPTY" will appear. Then, the power will be discon-
nected automatically.
Notes:
If you use the battery which you stopped charging half-
way, " " may appear. It does not mean that the bat-
tery is completely charged.
The battery indicator will not correctly display the remain-
ing capacity for approximately 10 seconds after the power
has been turned on.
When the AC adaptor or a separately available car adap-
tor is used, the battery indicator will not be shown.
The number of bars shown in the battery indicator may
increase or decrease, depending on the operation be-
ing performed. This is normal.
) during operation.
When the battery
level is very low