Ricoh RDC-i700 Operation Manual page 63

Tone Confirmation
When using the dial-up function, you need to set whether or not to wait for the
dialing tone. Select
factory default setting is [WITHOUT TONE].
If you are using an ordinary telephone line (analog line), select [AFTER TONE],
and if you are using an ISDN or mobile phone, select [WITHOUT TONE].
• AFTER TONE: waits for the dial tone before dialing
• WITHOUT TONE: does not wait for the dial tone before dialing
• The dial tone refers to the sound you hear when you lift the telephone
Note
receiver. The tone indicates that the telephone is working normally.
When using the dial-up function, you can check that the modem is
working normally by listening for the dial tone.
Checking the Modem Settings
This section explains the procedure for checking the modem settings.
A Turn the camera on and set the mode dial to [
The Setup menu will be displayed.
B Select [MODEM SETTING].
The modem setting screen will be displayed.
C Check the setting of each item.
Change the setting if necessary.
• P.60 "Modem Settings"
See
for either [AFTER TONE] or [WITHOUT TONE]. The
].
61
3