Checking The Modem Settings - Ricoh RDC-i700 Operation Manual

Checking the Modem Settings

Normally, when you have connected the camera to the communication
equipment, you can use the communication and Internet functions straightaway
as the various items have already been set on the most commonly used
settings at the time of shipping from the factory. However, depending on the
type of communication card used, communication may not proceed smoothly
with the settings as they are. You should therefore check the modem settings
when inserting the communication card for the first time.
• Provided that you do not change the type of communication card used,
Important
Note
there is no need to check the settings each time you use the
communication function.
Modem Settings
Check the following 4 items. If the communication and Internet functions do not
operate smoothly, change the settings to suit the type of communication card
used.
Slot
Select the slot ([PCMCIA] or [CF]) to insert the communication card.
• PCMCIA : when the communication card is inserted in the PC card slot
• CF : when the communication card is inserted in the CF card slot
Card Type
The type of communication card inserted (manufacturer and type) is displayed.
If a communication card of a type not recommended by Ricoh is used, it will not
work. Be sure to use the card recommended by Ricoh.
Qualified Products.
ADD AT Command
The AT command is for controlling the communication card from the camera. If
you wish to add an AT command, select [ADD AT CMD]. Normally, it is not
necessary to make such an addition.
• For details of the AT command, refer to the instruction manual
Note
supplied with the communication card.
60
The separate list of