Projection Stops Automatically - Epson dreamio EMP-TW500 User Manual

Image colours are not right
Are the image signal format
settings correct?
Are the cables connected
correctly?
Has the image Contrast
been adjusted correctly?
Has the colour been adjusted
correctly?
Have the colour intensity and
tint been adjusted correctly?
Only when projecting
images from a video
source
Images appear dark
Has the image brightness been
adjusted correctly?
Has the image contrast
been adjusted correctly?
Is the lamp due for
replacement?

Projection stops automatically

Is sleep mode active?
If a composite video or S-Video
If projection does not occur when the "Video Signal" menu command is
set to "Auto", select the signal format that matches the signal source.
"Setting" - "Input Signal" - "Video Signal" p.22
If the signal source is connected to the [InputA] port, [InputB] port or
[D4] port
Use the "Input Signal" menu command to set the signal format that
matches the signal that is being projected from the connected
equipment.
"Setting" - "Input Signal" p.22
You can also press ,
select the format. Setup Guide
Check that all of the cables required for projection are securely
connected. Setup Guide
Use the "Contrast" or "White Level" menu command to adjust the
contrast.
"Image" - "Picture Quality" - "Input Adjustment" p.16
Use the "Color Adjustment" menu command to adjust the colour.
"Image" - "Color Adjustment" p.17
Use the "Color Intensity" and "Tint" menu commands to adjust the
colour and tint.
"Image"- "Picture Quality" - "Color Intensity", "Tint" p.16
Use the "Input Adjustment" and "Brightness" menu commands to make
the adjustments.
"Image" - "Picture Quality" - "Input Adjustment", "Brightness" p.16
Use the "Contrast" or "White Level" menu command to adjust the
contrast.
"Image" - "Picture Quality" - "Input Adjustment" p.16
When the lamp is nearly due for replacement, the images will become
darker and the colour quality will become poorer. When this happens,
the lamp should be replaced with a new one.
If the projector remains on while no images signals are being input, after
a while the lamp will automatically turn off and the projector will switch
to standby mode. Press the
button on the projector's control panel to turn the projector's power back
on. To cancel the sleep mode setting, change "Sleep Mode" menu
command to "OFF".
"Setting" - "Operation" - "Sleep Mode" p.20
Problem Solving
signal is being input
or on the remote control to
p.42
button on the remote control or the
37