Replacing Consumables; Replacing The Air Filter; Replacing The Lamp; Resetting The Lamp Operating Time - Epson dreamio EMP-TW500 User Manual

Maintenance

Replacing Consumables

Replacing the Air Filter

Dispose of used air
filters properly in
accordance with your
local regulations.
Air filter frame:
Air filter:

Replacing the Lamp

If the lamp stops working
and needs to be
replaced, there is the
danger that the lamp
may already be broken.
If replacing the lamp of a
projector which has been
installed on the ceiling,
you should always
assume that the lamp is
broken and handle it with
extreme care during
removal. Furthermore,
you should stand to the
side of the projector, not
underneath it.

Resetting the Lamp Operating Time

The lamp operating time
must always be reset after
the lamp has been replaced
with a new one.
The projector has a built-in
lamp operating time counter.
A replacement message is
displayed when the counter
reaches a certain amount.
42
Turn off the power, wait
for the cool-down period
to finish (takes
approximately 30
seconds), then
ABS plastic
disconnect the power
cable.
Polypropylene
Turn off the power, wait
for the cool-down period
to finish (takes
approximately 30
seconds), then disconnect
the power cable.
* Wait until the lamp cools
down (takes
approximately 1 hour).
Install the new lamp.
Make sure that it faces the
correct way.
Press
the power.
to turn on
Remove the air filter
cover.
Put your finger
under the latch.
Lift up.
Loosen the screws fixing
the lamp cover.
Securely tighten the
lamp fixing screws.
Press to display
the configuration menu.