Problems When Projection Starts; Problems With The Remote Control; The Remote Control Does Not Work - Epson dreamio EMP-TW500 User Manual

Problem Solving

Problems when projection starts

Power does not turn on
Have you pressed the [Power]
button?
Is "Operation Button Lock" set
to "ON"?
Is the indicator lit orange?
Do the indicators turn off and
on when the power cable is
touched?

Problems with the remote control

The remote control does not work

Is the remote control light-
emitting area facing towards
the remote control light-
receiving area when it is
operated?
Is the remote control too far
from the projector?
Is direct sunlight or strong
light from fluorescent lamps
shining onto the remote
control light-receiving area?
Are the batteries dead, or have
the batteries been inserted
correctly?
38
Press on the remote control or
If the "Operation Button Lock" menu command is set to "ON", all
buttons on the projector's control panel are disabled. Press
remote control.
"Setting" - "Operation" - "Lock Setting" - "Operation Button Lock"
p.20
Disconnect the power cable and then reconnect it.
Check the circuit breaker to see if power is being supplied.
Turn the power off, disconnect the power cable and then reconnect it. If
this does not solve the problem, there may be a problem with the power
cable. Then contact your dealer or the nearest address provided in the
"International Warranty Conditions" of the Safety Instructions/World-
Wide Warranty Terms booklet.
Face the remote control towards the remote control light-receiving area.
The operating angle for the remote control is approximately ±30º
horizontally and approximately ±30º vertically.
Setup Guide
The operating range for the remote control is approximately 10m.
Setup Guide
Set the projector up in a location where strong light will not shine onto
the remote control light-receiving area.
Insert new batteries, while making sure that they face correctly.
Setup Guide
on the projector's control panel.
on the
Setup Guide