Problems Relating To Images; No Images Appear; The Message "Not Supported." Is Displayed - Epson dreamio EMP-TW500 User Manual

Problem Solving

Problems relating to images

No images appear

Have you pressed the [Power]
button?
Was the
before the power was turned
on?
Is blank mode active?
Is a video signal being input?
Are the image signal format
settings correct?
Have the configuration menu
settings been made correctly?
Were the projector and the
computer connected while
their power was turned on?
Only when projecting
computer images
Is the computer display output
set to only the computer's
accessory screen?
Only when projecting
computer images

The message "Not Supported." is displayed

Are the image signal format
settings correct?
Does the mode match the
frequency and resolution of
the image signals?
Only when projecting
computer images
34
Press
indicator lit orange
Disconnect the power cable and then reconnect it.
Check the circuit breaker to see if power is being supplied.
Press
Check if the power for the connected equipment is turned on. If the
"Message" menu command has been set to "ON", messages relating to
the image signals will be displayed.
Use the "Video Signal" menu command to select the signal format
which matches the connected signal source.
Try resetting all of the current settings.
If the connection is made while the power is already turned on, the
function (Fn) key that switches the computer's video signal to external
output may not work. Turn off the power for the projector and the
computer and then back on again.
The image signals need to be output externally. Change the output
setting to an external destination only or to an external destination as
well as the computer's own monitor.
If a composite video
If projection does not occur when the "Video Signal" menu command is
set to "Auto", select the signal format that matches the signal source.
If connected to the [InputA] or [InputB] port
Check that the connectors of the connection cable are inserted into the
correct ports.
Use the "Resolution" menu command to check the signals being input,
and check the "List of Supported Monitor Displays" to make sure that
the signals are compatible.
on the remote control or
Setup Guide
on the remote control to cancel the blank function.
"Setting" - "On-Screen Display" - "Message" p.21
"Setting" - "Input Signal" - "Video Signal" p.22
Computer documentation, under a title such as "External output" or
"Connecting an external monitor"
or S-Video
"Setting" - "Input Signal" - "Video Signal" p.22
Setup Guide
"Info" - "Resolution" p.15
"List of Supported Monitor Displays" p.45
on the projector's control panel.
p.23
signal is being input