Install The Printhead - Canon MultiPASS F60 Setup Sheet

Install the printhead.

IMPORTANT
• To turn off the machine, be sure to always press [ON/OFF(1sec.)]. This will ensure
that the printhead is capped and prevent it from drying up.
• If you are not using the machine for a long period of time, we recommend that you
print (in black and color) or clean the printhead approximately once a month to
maintain the printhead in good working condition.
Press [Open] q and lift up the scanning unit w. Then remove the tape A.
1
w
q
2
Remove the printhead from its packaging, then remove the orange protective
cap B.
B
Raise the lock lever D, then gently slide the printhead into the holder.
3
Lower the lock lever.
IMPORTANT
• Do not touch the lock lever once the printhead has been installed.
A
IMPORTANT
• Do not touch the electrical contacts C.
C
D
IMPORTANT
• Do not touch the metal rod or any
parts inside the machine.
• Do not turn off the machine when
opening the scanning unit.
Turn over to
Turn over to
continue continue