Install The Software - Canon MultiPASS F60 Setup Sheet

Install the software.

IMPORTANT
• DO NOT connect the USB cable before installing the software.
NOTE
• When installing the software in Windows XP or Windows 2000, log onto the system as a
member of the Administrator group.
• If you have previously installed an earlier version of the MultiPASS Suite software
(version 4.1 or earlier), you must remove it before installing this version. For details on
uninstalling the software, refer to the documentation of the previous version.
1
Make sure both your machine and computer are turned on.
2
On your computer, close any open applications, including virus checkers.
3
Insert the MultiPASS Suite CD-ROM into your CD-ROM drive.
• The setup program should start automatically. If it does not, double-click [My
Computer] in the Windows screen, double-click the CD-ROM icon, then double-click
[csplash] or [csplash.exe].
4
When the next screen appears, click
INSTALL MULTIPASS SUITE.
5
Follow the on-screen instructions.
When the message below appears, remove the label A from the USB port B
6
located on the back of the machine. Then connect a USB cable C (not included)
to the machine and computer.
Windows 98/Me/2000 Windows XP
B
C
NOTE
• If you cannot continue with
the installation after
connecting the USB cable,
refer to p. 11-1 of the Basic
Guide.
USB label A