Operation - Craftsman 113.177846 Owner's Manual

20 gallon wet/dry vac
Table of Contents

Advertisement

Available languages

Available languages

Accessory
and Hose Storage
Your accessories
may be stored in the
accessory storage bag, or in the two
locations on the power head assembly.
Location
Accessories
The hose may be stored by wrapping it
around the unit and plugging the open
end into one of the storage locations on
the caster feet or in the storage bag.
Open End
Of Hose
--
OR --
--
OR --
Accessories
Wand
__
Hose
Button
End Of Hose
Hose Storage
'y
y
Storage
Storage
Bag
Bag
Operation
Ak WARNING
To reduce the risk of fire or explosion, do not operate this vac in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or vapors
include but are not limited to; lighter fluid, solvent type cleaners, oil-base paints,
gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited to;
coal, magnesium, aluminum, grain or gun powder. Do not vacuum explosive dust,
flammable or combustible liquids or hot ashes. Do not use this vac as a sprayer.
To reduce the risk of health hazards from vapors or dusts, do not vacuum toxic
materials.
WARNING: Always wear safety
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
starting operation. Safety eyewear are
available at many local retail stores.
The operation of any utility vac can
result in foreign objects being blown
into the eyes, which can result in
severe eye damage.
CAUTION: To reduce risk of
hearing damage, wear ear protectors
when using the vac for extended hours
or when using it in a noisy area.
To reduce the risk of electric shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit
in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position 'T'. The
symbols used on the switch actuator are
international "On & Off" symbols. "O" is the
symbol for "OFF" and 'T' is the symbol for
"ON".
10

Advertisement

Table of Contents
loading

Table of Contents