Bevel Stop - Craftsman 315.108241 Owner's Manual

O EFIATION
TO ADJUST BEVEL SETTING
1. Unplug your saw.
2, Loosen wing nut. See Figure 15_
3 Raise motor housing end of saw until you reach desired
angle setting on bevel scale, See Figure 15.
4, Tighten wing nut securely.
POSITIVE 0 ° BEVEL STOP
See Figure 17.
Your' saw has a positive 0° bevel stop, that has been factory
adjusted to assure 0 ° angle of your saw blade when making
90 ° cuts. However, misalignment can occur during shipping.
TO CHECK
1. Unplug your saw.
2 Place yoursawin an upside down position on workbench
See Figure 17.
3. Using a carpenter's square, check squareness of saw
blade to the base of your saw.
TO ADJUST
1. Unplug your saw.
2. Loosen wing nuL
3, Loosen hex nut securing adjustment screw,
4. Turn screw and adjust base until square with saw blade.
5_ Tighten hex nut and wing nut securely.
LOWER BLADE GUARD
Fig. 16
= i, i= ..... ,
BEVEL ADJUSTMENT
ADJUSTMENT SCREW
WING NUT
HEX NUT
POSITIVE 0 ° BEVEL STOP
CARPENTER'S SQUARE
W BLADE
17
Page 10