Craftsman 113.298760 Owner's Manual page 17

7,. Slide SPREADER ROD into BLADE GUARD
SUPPORT until end of ROD is even with edge of
SUPPORT • Tighten Hex Head Screw in
support,
8. Attach SPREADER to SPREADER SUPPORT so
that the edge of the spreader is even with the
edge of the spreader support . tighten screws,
9 Raise ANTIKICKBACK PAWL (hold it in place
with a piece of masking tape)
. align spreader SQUARE to table
Tighten both 5/t6-18 x 1 in,, HEX HEAD
SCREWS.,
1/4_20 HEX
HD. SCREW
1/4 INo LOCKWASHER
1/4-20 HEX NUT
SPREADER EDGE
EVEN WITH SPREADER
SUPPORT EDGE
END OF ROD
EVEN WITH EDGE
OF SUPPORT
5/16-18 X 1 IN.
HEX HD_ SCREWS
r
t0. Raise blade all the way up
square with table,
make sure it is
1t Raise Blade Guard lift up both ANTIKICK-
BACK PAWLS .... insert one of the SETSCREW
WRENCHES in the notches to hold the pawls out
of the way.
I2 Lay blade of square or other straightedge along-
side of blade,
I3, Loosen Hex Head Screw in BLADE GUARD
SUPPORT and move spreader so that it touches
blade of square .,, tighten screw.
14 NOTE: The spreader is now square with the table
and approximately in line with the sawblade, The
spreader requires further adjustment to align it
PARALLEL to the blade and in the MIDDLE of the
cut (KERF) made by the sawblade,
HEX HD,
SCREW
15..IMPORTANT: To work properly, the SPREADER
must always be PARALLEL to the sawblade and
adjusted so the cut workpiece will pass on either
side at the spreader without binding or skewing
to the side.
NOTE: The spreader is thinner than the width of
the cut (KERF) made by the sawblade by approxi-
mately six thicknesses of paper.
LOOKING DOWN ON SAW
17