Craftsman 113.298760 Owner's Manual page 19

7 Fromamongthe looseparts,
find the following
hardware:
4 Carriage Bolts, 5/16-18 x 3/4 in.. long
4 Hex nuts, 5/16-!8 (approx dia.. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type (approx dia
of hole 5/16 in)
I Cast Iron Motor Pulley
8. The motor base is installed in the cradle for ship-
ment. Pull the motor base away from the cradle and
put it on the floor before mounting the motor to it..
9 PtacemotoronMOTOR BASE ..,insertboltsthrough
holes in MOTOR BASE ...... then through the motor
MOUNTING BASE. Install lockwashers and nuts.
I0 Position motor so that edge of MOTOR MOUNTING
BASE and MOTOR BASE are even as illustrated,..
slide motor all the way to the RIGHT ... tighten the
four nuts
t 1 Loosen set screw in motor pulley using 5/32 in. Hex
"L" wrench. Slide pulley onto shaft with HUB away
from motor° DO NOT TIGHTEN SET SCREW..
12. Install 3/I 6 in. square key (furnished with motor) in
grooves inpulleyand motorshaft.. DONOTTtGHTEN
SET SCREW.
5/16
NUT
5/16-18
\o
THESE TWO ,CARRIAGE BOLT
EDGES 5/16-18 X 314 IN,,
KEY
CRADLE
MOTOR BASE
t: J
MOTOR MOUNTING
BASE
[
PULLEY
!3
Lift motor and insert the TWO PINS on motor base
into HOLES IN cradle, push motor in as far as it will
go
\
I
CRADLE
19