Craftsman 113.298760 Owner's Manual page 15

If fence does not slide easily along the bars, the
pressure of the spring can be REDUCED
1 Loosen the screws
2, Move spring slightly toward rear of fence ,
tighten screws,
WARNING: TO AVOID INJURY FROM JAMS OR
KICKBACK, BE SURE TO PROPERLY ADJUST AND
PUSH LOCK LEVER ALL THE WAY DOWN UNTIL
THE LEVER RESTS ON THE STOP BEFORE USING
THIS RIP FENCE.
SPRING
SLIDE SPRING TO
ADJUST PRESSURE
RIP FENCE LOCK LEVER ADJUSTMENT
The rip fence lock lever when locked down, should hold
the rip fence securely, it should not be difficult to push
down and lock,
If lock lever does not lock fence securely .,
1 Raise lock lever.
2. Tighten the adjusting nut using a small screwdriver
until the lever, when locked, holds the rip fence
securely
If lock lever is difficult Io push down
1,, Raise lock lever_
2.. Loosen the adjusting nut using a small screwdriver
until the lever is easy to push down and holds 1he rip
fence securely,,
RIP FENCE ALIGNMENT ADJUSTMENT
The rip fence must be PARALLEL with the sawblade and
Miter Gauge grooves.,, Move fence until it is along side
of groove, Do NOT LOCK IT, It should be parallel to
groove.. If it is not;
1. Loosen the two "Hex Head Screws",
2,, Hold fence head tightly against bar, ,. move end of
fence so that it is parallel with groove.,
3, Alternately tighten the screws,
4 Recheck alignment,
5,, Repeat steps as needed.
FENCE
HEAD
HEX SCREWS
FENCE HEAD
15