Setting The Clock; Channel Search - Zenith VRL4170 Operating Manual & Warranty

Installation
Unpack The VCR
and All Accessories
Disconnect antenna from your
TV or other units. Position
VCR in desired location, away
from any interfering wiring.
Turn the VCR around so you
are looking at the back side and
locate the connections panel.
Note: It is important to place
the VCR where you plan on
using it. After setting the Clock
;and completing the Channel
Search, if you disconnect the
VCR power cord some of that
iinformation will be erased.
O'his will also occur if there is
a power failure.)
Diagram A is designed to help
you connect your VCR to your
antenna and TV set.
Step 1.
Connect your antenna cable to
your VCR using the VCR ANT
IN jack located on the back
panel of the VCR as shown. (If
this is not how your antenna
cable looks you may need addi-
tional adapters to complete
these connections. Refer to
page 4-2 for connecting your
VCR).
Step ;!.
Connect the hookup cable sup-
plied with your VCR to the
VCR ANT OUT jack. Connect
the other end to the ANT IN
jack on the TV set.
Step 3.
Slide: the CH3-4 switch so it is
in the CH 3 position; this sends
the VCR signal to the TV set
over channel 3. (If CH 3 does
not work slide the switch to
CH 4.)
Diagram A. VCR Back Panel Cable Connections
Antenna Connections
Connect the antenna to the
VCR and the VCR to the TV.
]{fyou have CATV (Cable TV)
use the connections detailed on
page 4-3.
Notes:
If you are replacing an exist-
ing VCR, disconnect your
old VCR and connect the
new VCR in the same way.
If this is your first VCR in-
stallation refer to Connec-
tions 4-2 for hookup
procedures.
For basic first-time connec-
tions, proceed as shown in
Diagram A.
Step 2 Hookup
Cable
'D----_CH4 Step 3 CH3-4
CH 3
Switch
Step 1 From
Cable/Decoder Box or
CA-TV Antenna (No
Decoder Box)
Hookup Cable
,,>luo 4 -- 1