Table of Contents
Advertisement
VCR Menu Settings
:Set the Current
Time
:Set the clock on the front of the VCR in the mes-
:;age center. Use the VCR remote control to
place the on-screen
display on your TV screen.
1. Press MENU on the remote
control. The Main
]Menu (VCR Features) appears on your TV
screen.
2. Press I on the remote
control.
This will bring you to sub-menu
DATE
SET.
Set the Month
The first two numbers
would be the month.
Enter
the month
by number;
use the numbered
keys on
the remote
control.
For example
April, the 4th month of the year,
would be entered
as 04, December
the 12th
month of the year would be entered
as 12. If you
make an obvious mistake
the on-screen
display
will show a ? where the correct
number
should
be. Press ADJ to erase errors.
Programming
Tip: If you are having difficulties
press QUIT, then re-enter the Main Menu by
pressing
MENU on the remote control to start
over.
Set the Date
q_e next two numbers would be the date. For ex-
ample
03 would be the 3rd day of November.
The
last two numbers are the year. For example,
1994
would be entered
as 94.
Set the Time
Enter the hours, then the minutes, then press
AM/PM
on the remote control to choose AM or
PM. For example
9:35 in the morning
would be
entered
as 09 35 AM.
Fleceiving VHF/UHF
TV Programs
or Cable
1V Service
Select Channel
3 on your TV to receive
televised
programs
from the VCR Tuner.
Press MENU
on the remote
control
to bring up
the Main Menu (VCR Features)
on the TV
screen.
Press 4 to choose TUNING
FEATURES.
Press 1- Tuning
Band. The on-screen
menu for
TUNING
BAND
appears.
Press ADd to choose TV if you only receive
UHF/VHF
CHANNELS.
Choose
CATV
if you
have cable service.
Press SELECT to move to sub-menu AUTO
CHANNEL. SEARCH.
VCR Tuner Channel
Search
Press ADJ to begin the VCR automatic
channel
search program. The VCP, searches for the avail-
able channels you receive in your local broadcast
area. When the search t)rogram is cornplete the
channels that were found will be indicated as
CHANNELS
FOUND and be followed by the
number of channels that were found. For ex-
ample, CHANNELS
FOUND
14.
The VCR has automatically programmed
itself to
receive those channels. Press QUIT on the
remote control; the first channel's program will
appear on your TV screen.
Note: Make sure you have chosen ON from the
VCR On-Screen Display sub-menu so that the
channel number will appear momenrarily in the
upper right hand corner of the TV screen each
time you change channels.
As you press CHANNEL Up or Down each chan-
nel the VCR has found 'will be shown on the TV
screen and the channel :m:tmber will also be
shown in the VCR message center.
Some channels may be too weak to send a picture
(adequate viewing signal) to the VCR.
To eliminate these channels in the channel
memory sequence that the VCR has tuned, write
down the numbers of these "weak" channels and
proceed as follows.
Channel Save/Skip
I. Press MENU on the renaote control.
2. Choose
main menu it,...na4-TUNING
FEA-
TURES.
_,61vo
5 - 2
Advertisement
Table of Contents
