Recording - Zenith VRL4170 Operating Manual & Warranty

I
VCR Front Panel Controls
Q) Qb
Qb
Q.
L#_
b
,]
IF t,.,:
RE_'
C .lt.I.
t_SPEED SEARCH--J _,
PAUSE
1. POWER -- Press to turn VCR on or off. Red
light will be on while VCR is on.
2. EJECT - Press once to eject tape.
3, CASSETTE LOADING COMPARTMENT
DOOR -- Insert your VHS cassette tape into the
compartment until VCR loads the tape.
4. PLAY -- Press to play a tape in the VCR.
5, REW -- Press to rewind a tape in the VCR.
6. STOP -- Press to stop playing a tape.
7. F FWD -- Press to fast forward a tape in the
VCR.
8. PAUSE -Press to momentarily cease VCR record-
ing or to obtain a still picture while playing a tape.
9. VIDEO - Front panel alternate video input jack.
10. AUDIO - Front panel alternate audio input jack.
11. VHS Logo - You must only use tapes that
have the VHS symbol on them.
12. AM - Symbol tells you current time is set at AM.
13. PM - Symbol tells you current time is set at PM.
14. CLOCK]MESSAGE CENTER -- Clock
remains on whether VCR is operating or not. If a
power failure occurs the clock will reset to SET
CLOCK.
A
power failure will also erase some
information; the same will happen if you discon-
nect the power cord.
Message Center - Info:rmation will be displayed
in the message center detailing the VCR's cur-
rent operational mode.
15. CASSETTE LOADED VCR SYMBOL-- A
cassette tape is loaded _md ready for operation in
the cassette loading corapartment.
16. VCR - This symbol lights when the VCR
mode has been selected! by means of the
TV/VCR key on the remote control or bYplaying
a tape.
17. REC ITR -- Press to make an instant record-
ing of what you see on your "IV screen or other
video input.
18. CHANNEL UP -- Pre:;s once to n_tovechannel
number to the next set higher channel.
19. SP/LP/EP -Press to change tape recording
speed. SP is Standard Play, LP is Long Play and
EP is Extended Play.
20. CHANNEL DOWN -- Press once to move
channel number to next set lower channel.
z,x:_o 1 - 1