Zenith VRL4170 Operating Manual & Warranty page 7

VCR Back Panel Connection Jacks
CH4
__.JCH3
The OUT jacks will be used to send the VCR sig-
nals out to other sources.
The IN jacks will be
used to bring signals into the VCR. (See Installa-
tion.)
Use these jacks for improving the audio and
video signal performance of the VCR by, for ex-
ample, connecting the VCR to a stereo system or
to the input jacks on a stereo TV. They are also
used to connect other units such as a video
camera" camcorder, Stereo Hi-Fi or another
VCR for dubbing purposes. These other sources
are accessed by changing the VCR source to
AUX mode. (See Section 5 VCR Setup.)
1..Audio
AUDIO OUT- Connection jack used to send the
VCR audio signal to other sources
AUDIO IN - Connection jack that receives the
audio signal of a video camera, camcorder or
other source.
2. Video
VIDEO OUT- Connec,_ion jack for sending the
VCR signal to another source.
VIDEO IN -- Connection jack that receives the
video signal from a video camera, camcorder or
other source.
3. ANT OUT - Connect hookup cable supplied
with this VCR from this jack to Antenna In on
your TV set or other u_Lit,
4. ANT IN - Connect
your existing antenna or
CATV cable to this jade.
5. Oh 3-4 - VCR output channel switch. Set this
switch to send the VCR sigaal to your'IV set. Use
channel 3; if3 does not work use channel 4. The TV
will receive the signal from your VCR over this chan-
nel Your TV set's channel and this VC'R switch must
both be set to the same n_aber; either 3 or 4.
VCR Front Panel Alternate Audio]Video Connection Jacks
))_ AI.IDIO VIDEO
i
f
6. AUDIO -. Alternate front audio connection
jack that receives the audio signal of a video re-
corder, camcorder or other source.
7. VIDEO -- Alternate from video connection
jack that receives the video signal of a video re-
corder, camcorder or other source.
2_,_o 2 - 1