Zenith VRL4170 Operating Manual & Warranty page 44

II
VRLA170 Quick Reference Guide
Recording Using the Timer
Turn on both the TV set and VCR. (You must
have specified either "IV or CATV in the Tuning
Features submenu, see Installation Section.)
Insert a VHS video cassette tape into the cassette
loading compartment on the front of the VCR.
Make sure the safety tab on the video cassette is
intact.
Select channel 3 on the TV set.
Change the remote control to VCR mode.
Press MENU on the remote control to choose the
Main Menu (VCR Features).
Select 2-Prograrn Record.
Enter the required information using the remote
control. Date of the Program. Start Time and
Stop Time. Choose the Channel. Choose the
Recording Speed. Choose the number of times
you want to record this program, Once, Weekly
(1 time each week) or Daily (the same time each
day Monday through Friday).
When finished programming the Timer, press
TIMER once to turn offthe VCR and set it into
Timer Recording mode.
Note:The VCR
cannot be turned on while it is in
the Timer mode. Ifyou want to use the VCR
before your recorded program broadcast time,
press TIMER on the remote control to release
the VCR from the Timer mode. Once the Timer
is activated TIMER SET will appear in the VCR
message center.
When the program comes on that you wish to
record you can also watch it, press TVNCR once
on the remote control then turn on the TV set
and ttme it to channel 3.
Note: For recording CATV (cable) broadcasts
the cable box must be on and tuned to the same
channel you wish to record.
When the timed program is finished the VCR
will turn itself off until the next timed program (if
there is one); if not press TIMER to release VCR
from 'Timer mode.
Recording/Playing Tapes wiLtha Camcorder
Turn on the TV set and the VCR.
Press MENU on the remote control to choose the
Main Menu (VCR Features).
Choose 4-Tuning Features; press the number 4
key. This brings up the Tuning Features sub-
menu.
Press number 4 to choose Source Select.
Press ADJ to place the arrow next
to
the word
AUX. Camcorders use the AUX inputs -
AUDIONIDEO
IN. (When finished recording
you will reset the arrow so it points to TUNER).
Connect the camcorder cables into the VIDEO
IN, AUDIO IN jacks on the back of the VCR.
Insert a VHS cassette into the VCR cassette
loading compartment. Make sure the
safety
tab is
intact.
Turn on the camcorder and
start
recordinffplay-
ing. (Refer to camcorder operating guide :for in-
formation about camcorder particulars.) To stop
recording/playing momentarily, press PAUSE on
the VCR or remote control. When finished
recording/playing press STOP on the VCR or
remote control. To eject the tape press EJECT
on the VCR.
When you are finished with the camcorder, the
VCR source select option will have to be
switched back to TUNER.
Press MENU on the remote control.
Press 4 to choose TUNING KEATURES, When
that sub-menu comes up on tl_e TV screen press
ADJ to place the arrow so it is.next to the word
TUNER; this resets the VCR back to normal
VCR mode.
Recording With VCR Plus
Turn on all system components; TV, VCR =rod
cable box. Tune TV to channel 3. Use the remote to
switch to VCR mode. Press VC:RPLUS, follow on-
screen instructions. (See page 1.0-1.)
z613-o QRG - 2