Table of Contents
Advertisement
VCR Menu Settings
3. Choose
CHANNEL
SAVE/SKIP.
Each chan-
nel the VCR tuner has found will come up in
numerical
sequence.
As you press CHANNEL
up
choose
SKIP to delete any weaker
channels
as
desired.
Choose
SAVE to keep the channels
with
an adequate
signal. Repeat
this procedure
to
eliminate
any other weak channels.
For example,
if Channel
27 comes in but is too weak for view-
ing, press ADJ so the word SKIP appears next to
tire weak channel's
number.
Press QUIT on the
remote
control
when finished
with the Channel
SAVE/SKIP
procedure.
Now when you press the
CHANNEL
Up/Down
keys only strong signal
channels
will be tuned
in and weak ones skipped
using the VCR tuner. Tune channels
with a cable
box at the cable box.
Choosing
Channels
The remote
control must be set to the VCR
mode to choose channels
on the VCR. You can
choose a channel by using either
the CHANNEL
Up/Down
buttons
on the VCR or the remote con-
trol, or by using the numbered
keys on the
remote
control to choose the channel
number
directly (32 for example)
and pressing ENTER to
switch the VCR Tuner
to receive that channel.
The channeI number will be shown in the upper
right hand corner of the VCR on-screen
display
which will appear momentarily
on your TV
screen each time you change channels
or initiate
a VCR operation.
VCR Function
On-Screen
Display
The TV 4-corner
VCR status on-screen
display
shows the channel
you chose using the VCR
tuner, and also the function
the VCR is perform-
ing, PLAY,
RECORD,
STOP, etc., will be dis-
played on the TV screen for a short time.
T3_pical 4-Corner
VCR Status On-Screen
Display
STOP--
Indicates
the VCR is in the Stop Mode.
SP -- Indicates
tape speed is set for Standard
Play.
f
STOP
VCR CH 11
SP
15 Mon
7:17
AM
1:35:45
J
VCR CH 11 - Indicates
VCR mode is active and
the VCR Tuner
is set to Channel
11.
15 Mon-
The date the VCR is set aL
7:17 AM - The time the VCR is set at.
1:35:45 -- Tape position :indicator is :at 1 hour, 35
minutes and 45 seconds.
Power Failures
Occasionally a power failure occurs. "]['heresult is
that all the information programmed
into the
VCR has to be re-entered'. If you were away
when this occurred and notice that the clock date
and time are missing and :SET CLOCK appears,
then there was an interruption
in electrical ser-
vice to your VCR.
Error Messages
As you use the menu system, if a problem or con-
flict occurs the menu system alerts you with an
error message on the TV ,;creen, like "'No Cas-
sette." For example, if you entered all the infor-
mation for a timed recording and pressed the
TIMER key to set the VCR into TIMER Mode
and no tape was loaded :into the tape loading com-
partment,
then that error message would appear
on your TV :screen.
261_-o
5-3
Advertisement
Table of Contents
