Table of Contents
Advertisement
F. Preparing The Installation
Location
Note: Please also refer P.11 "J. Making the Electrical Connection'
1. A. If you want to move the electric range to make room for working on
the cabinet turn off the 220 volt power for the electric range at the
service entrance.
B. Before moving a gas range. shut off the gas.
Note:
Omit steps 2a through 2d if the hood is to be mountedon a cabinet
with a flush bottom.
2. For installation onto a recessed bottom cabinet:
a. Measure the space (under the cabinet between the inside front
edge and inside back edge (Fig.5). With a saber. cut two 1"x2"
wood filler strips (purchased locally) to fill in the bottom of the
cabinet.
b. Start a 1 Y4" long wood screw (purchased locally) about 3" from
each end of the 1"x2" wood strips (Fig.6)
c. Position the strips on the cabinet bottom and screw the strips
securely to the cabinet (Fig.7)
d. For a more secure installation. drill four 3/16" holes from inside
the cabinet. down into the wood filler strips. Insert screws into the
starter holes in cabinet and tighten screws until wood filler strips
are secured under cabinet.
3. Center the hood in place beneath the cabinet and flush with the front
of the cabinet. Mark the following:
a. The four keyhole mounting slots for the hood. Mark these onto the
bottom of the cabinet; or. if the cabinet bottom is recessed. Onto
the wood strips (Fig. 7)
b. The electrical knockout hole. (Fig.1)
Flg.5
-6-
Fig.6
Advertisement
Table of Contents
