Tools And Materials Required - Windster RA-3030 Operation Manual

c. Tools and Materials Required
~ Drill.electric of ratchet drive. with 3/16" wood bit (for drilling starter
holes and 1 ¥4 "wood bit (to drill an access holes in the cabinet or
kitchen wall for the electric power line)
~ One common screwdriver.
~ Plier (for opening electrical knockout).
~ Two 1" (thick)x2" (wide)x12" (approximate length) wood strips for
recessed bottom kitchen cabinet installation only. (Purchase locally).
~ Electrical wire and supplies to comply with local cords.
~ Four 1 ¥4 " long flat head wood screws (purchase locally) to mount
wood strips.
~ Pencil and ruler for marking locations. Saber saw or keyhole saw for
cutting the 1"x2"wood strips to length.
D. Ducting
This style of range must be vented via ducting to the outside of the house
Follow general rules when ducting the hood: Use correct size of ducting
at least 6" round. do nof reduce size of ducting. make all turns gradual.
no short corners. If ducting ran will be longer than 10 feet enlarge duct by
at least 1" inch diameter after each 10 feet. Tape all joints in ducting and
all gasketed openings on hood for a tight seal.
For round ducting from the top:
Fit the gray plastic (Included) over the circular opening on top in order
to providea tight seal for ducting to attach to. The
GRAY ring is designed
to fit 6"and 7" ducting.
-4-