Deluxe Controller Fault Codes - Windsor chariot iSCRUB CS24 10060210 Operating Instructions Manual

MACHINE TROUBLESHOOTING – DELUXE CONTROLLER FAULT CODES
ERROR
CODE
DELUXE
None LCD display on, but incomplete
0A01 Power down error
0204 Memory corrupt
All 080_ codes Throttle wiring
All 140 _ Codes
Possible short circuit of motors, auxiliary
outputs (headlight, recycle pump, or back-
All 310_ Codes up alarm), wiring or damaged controller
7500 LCD module communications timeout
7501 LCD module settings corrupt
All 760_ Codes Brush motor or brush circuit fault
All 770_ Codes Vacuum motor or vacuum circuit fault
7800 Traction motor open circuit fault
7801 Traction motor overcurrent error
7802 Traction motor in power foldback state
All 790_ Codes Emergency stop error
9000 Brush current requirement not satisfied
4-31
PROBLEM
86037660 CHARIOT 05/27/08
SOLUTION
Disconnect batteries and wait 1 minute before
re-applying power.
Disconnect batteries and wait 1 minute before
re-applying power.
Replace controller.
Check for short or open circuits in throttle
wiring.
Check for short circuit between B+ and
traction output.
Check for short circuits. If code is present
after short circuits are repaired, replace
controller.
Wiring fault on 6-way serial link between
controller and display.
Disconnect batteries and wait 1 minute before
re-applying power.
Check for short or open circuits in brush
motors or wiring.
Check for short or open circuits in vacuum
motor(s) or wiring.
Check for open circuit on propel motor or
wiring.
Check for short circuit on propel motor or
wiring.
Propel motor current has exceeded current
limit for the foldback time.
E-stop input active or wiring fault.
Check that brushes or pads are installed.
Check for open circuit in scrub lift actuator,
circuit breaker or wiring.