Windsor chariot iSCRUB CS24 10060210 Operating Instructions Manual page 32

MAINTENANCE-BATTERIES
5. Replace the battery caps, and leave them in
place while charging.
6. Unplug the battery connector from the machine.
FOR SAFETY: When charging, connect the
charger to the batteries before connecting the
charger to the AC wall outlet. Never connect the
charger to the AC wall outlet first. Hazardous
sparks may result.
7. Plug the charger connector into the battery
connector. Connect the charger AC plug to a
wall outlet. The charger gauge should indicate
that the batteries are charging.
8. When the batteries are fully charged, disconnect
the charger from the AC wall outlet, then
disconnect the charger from the batteries.
9. Connect the batteries to the machine connector.
10. Check the electrolyte level. It should be up to
the indicator ring. If necessary, add distilled
water.
11. Install the rear cover.
4-5
CHANGING BATTERIES
Stop the machine in a clean area next to the
charger. Turn off machine.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn off machine
and remove key.
1. Remove the rear cover.
2. Disconnect battery pack from machine.
3. Unlatch battery tray from machine and pull out
to expose batteries.
4. Use the proper size open end wrench to
disconnect main ground wire first and secure
cable terminal away from batteries.
5. Disconnect main positive lead and secure cable
terminals away from batteries.
6. Loosen both terminals on each jumper cable
and remove one at a time.
7. Prepare a suitable site to place the batteries.
Batteries are a potential environmental hazard.
Consult your battery supplier for safe disposal
methods.
86037660 CHARIOT 11/09/06
Attach suitable battery lifting
device and lift batteries from
the machine.
RED RED
+ +
- -
BLK BLK
REAR OF MACHINE
RED
+
-
BLK