Setting Up Netware Session - Kyocera TASKalfa 650c Manual

7.COMMAND CENTER ADMINISTRATOR MODE
- Digital signature is always done for the communication on the server side. — Select this to allow the
communication only when a client accesses this equipment with a digital signature. When a client accesses this
equipment without a digital signature, the communication is not allowed.
- Digital signature isn't done for the communication for the server. — Select this to allow the communication
only when a client accesses this equipment without a digital signature. When a client is set to always access a
SMB server with a digital signature, the communication is not allowed.
If you do not know whether the SMB Signing of SMB Client is enabled or disabled in the client computers, it is
recommended to select [If client agrees, digital signature is done for the communication.]. If this is set incorrectly,
the SMB communication may become unavailable.
12) SMB Signing of SMB Client
Select whether SMB Signing is enabled or disabled when this equipment accesses the clients using SMB, such as
when this equipment stores the scanned data in the network folder using SMB.
- If server agrees, digital signature is done for the communication. — Select this to use the digital signature to
secure the communication to a SMB server only when the SMB Signing of SMB Server that this equipment
accesses is enabled. If the SMB Signing of SMB Server is disabled in a SMB server, the communication is
performed without the digital signature.
- Digital signature is always done for the communication on the client side. — Select this to make this
equipment always access a SMB server with a digital signature. When the SMB Signing of SMB Server is disabled
in a SMB server, the communication is not allowed.
- Digital signature isn't done for the communication for the client. — Select this to communicate to a SMB
server without the digital signature. If the SMB Signing of SMB Server is always enabled in a SMB server, the
communication is not allowed.
 If you do not know whether the SMB Signing of SMB Server is enabled or disabled in the SMB servers, it is
recommended to select [If server agrees, digital signature is done for the communication.]. If this is set
incorrectly, the SMB communication may become unavailable.
 When communicating the Windows Server 2003 as a SMB server, it is recommended to select [If server
agrees, digital signature is done for the communication.] or [Digital signature is always done for the
communication on the client side.], because the SMB Signing of SMB Server is enabled on the Windows Server
2003 as the default.
 Setting up NetWare Session
In NetWare Session, you can set the NetWare Bindery or NDS service. This must be set when configuring a Novell
printing environment.
1
2
3
4
5
1) Enable Bindery
Select whether the NetWare Bindery mode for Novell printing is enabled or disabled. When you configure a Novell
printing environment with the NetWare server in bindery mode, you must enable this.
2) Enable NDS
Select whether the NetWare NDS mode for Novell printing is enabled or disabled. When you configure a Novell
printing environment with the NetWare server in NDS mode, you must enable this. When this is enabled, you should
also specify the context and tree for the NDS.
3) Context
Enter the NDS context where the NetWare print server for this equipment is located.
7 COMMAND CENTER ADMINISTRATOR MODE
Setting up From COMMAND CENTER 121