Checking Network Connections - Canon imageCLASS MF4570dw Settings Manual

Troubleshooting

Checking Network Connections

Check the following items to make sure that the machine is ready to be connected to a network.
Check the status of the computer to make sure that it is ready to be connected to a network.
Have the settings for the computer, the wireless LAN router, or access point been completed?
Check
Is the power cable or network cables for the wireless LAN router or access point disconnected?
Check
* If the cables are loose, properly reconnect them.
Is the wireless LAN router or access point turned ON?
Check
If you cannot connect to the Internet even after checking
Turn OFF each device and turn it back ON.
Wait a few moments, and check if you can connect to the Internet again.
Check the power on the machine.
Is the power turned ON?
Check
When the power is already turned ON
Turn the power OFF and turn it back ON.
Check if the installation sites for the machine, the wireless LAN router, or access point meet the following conditions.
The distance between the machine and the wireless LAN router or access point is within 164' (50 m)
(may vary on the communication speed or environmental condition).
Check
There is no obstacle such as a wall between the machine and the wireless LAN router or access point.
Check
Microwaves and refrigerators are not nearby.
Check
Install the machine and the wireless LAN router or access point in locations that meet these requirements.
The wireless LAN router
or access point
Specify the settings again after checking the items from
Proceed to "Step4-A Setting the Machine Using the WPS (Push Button Mode), " on P.1-4.
Proceed to "Step4-B Setting the Access Point Manually and Connecting, " on P.1-6.
Refer below if you cannot connect the machine to the network after checking all items
2-6
5m
Within 164' (50 m)
Wall Microwave Refrigerator
to are complete.
machine