Canon imageCLASS MF4570dw Settings Manual page 7

9.
Check that the Wi-Fi indicator is blinking.
When the wireless LAN or access point is detected, the
WiFi indicator blinks.
The next screen is displayed for approximately 2 seconds,
and the Wi-Fi indicator will start blinking.
Connected.
If an Error Message Appears
Press [OK] to close the screen, and repeat from
6
procedure .
If the access point cannot be detected even after
retrying, see the following.
Proceed to "When an Error Message Appears, " on P.2-2.
The wireless LAN setting is completed.
10.
11.
Next, install the software.
For details, please refer the "Starter Guide".
Setting the wireless LAN
Wait until the machine retrieves the IP
address automatically (approx. 2 minutes).
If you want to set the IP address manually, see
the following.
e-Manual "Network Settings" - "Basic Network
Settings" - "Setting the IP Address"
Check the network connections
Check the operation using a computer which is
connected to a network.
Proceed to "Checking the Wireless LAN Setting
is Completed, " on p.Appendix-1.
1-5