When An Error Message Appears - Canon imageCLASS MF4570dw Settings Manual

Troubleshooting

When an Error Message Appears

"Cannot fi nd access point."
 WPS – When specifying the settings in push button mode
When searching for an access point, the WPS button on the wireless LAN router or access point
was not pressed within 2 minutes.
Specify the settings again.
Check the network connection if the message still appears.
 When setting by manually selecting an access point
The machine cannot detect the wireless LAN routers or access points because there is a problem
with the network connection.
Check the network connection.
"Could not connect. More than one access point was detected."
Other wireless LAN routers or access points within the connection range were detected.
Wait a few moments and specify the settings again.
"WPS connection failed."
An error occurred while specifying the settings using the WPS function, resulting in a connection
failure.
Check if the wireless LAN router or access point that you are using supports
the WPS function.
[If it is supported]
[If it is not supported]
2-2
Proceed to "Step4-A Setting the Machine Using the WPS (Push Button Mode), " on P.1-4.
Proceed to "Checking Network Connections, " on P.2-6.
Proceed to "Checking Network Connections, " on P.2-6.
Proceed to "Step4-A Setting the Machine Using the WPS (Push Button Mode), " on P.1-4.
( Proceed to "Selecting a Method for Setting the Wireless LAN, " on P.1-3.)
Check the network connection.
Proceed to "Checking Network Connections, " on P.2-6.
Set the access point manually.
Proceed to "Step4-B Setting the Access Point Manually and Connecting, " on P.1-6.