Energy Saver Function; Auto Sleep - Kyocera 1102RX3NL0 Operation Manual

Installing and Setting up the Machine > Energy Saver function

Energy Saver function

If a certain period of time elapses after the machine is last used, the machine automatically enters sleep mode, which
minimizes power consumption. If the machine is not used while in sleep mode, the power automatically turns off.

Auto Sleep

Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The amount of time before entering Sleep is as follows.
• 1 minute (default setting)
If print data is received during Sleep, the machine automatically wakes up and starts printing.
To resume, perform the following actions.
• Select the [Go] key.
Recovery time from Sleep Mode is as follows.
• Within 10 seconds
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
1
Display the screen.
1
[Menu] key > [▲] [] key > [Device Common] > [►] key > [▲] [] key > [Timer] > [►] key
2
Enter the administrator ID and select the [OK] key.
NOTE
Enter an ID consisting of between 1 and 16 numbers.
Select the [▲] or [▼] key to enter a number.
Select the [◄] or [►] key to move the cursor left or right.
The factory default settings for the administrator ID is 4000.
3
Enter the administrator password and select the [OK] key.
NOTE
Enter a password consisting of between 0 (no settings) and 16 numbers.
Select the [▲] or [▼] key to enter a number.
Select the [◄] or [►] key to move the cursor left or right.
The factory default settings for the administrator password is 4000.
4
[▲] [] key > [Sleep Timer] > [OK] key
2-27