Tools And Materials Required; Cabinetry/Ductwork; Cut The Opening - GE Monogram ZGU365 Installation Instructions Manual

Tools and
Materials
Required
Top View–Countertop Surface
Cut the
Opening
Measure carefully when cutting countertop.
Make sure sides of opening are parallel and
rear and front cuts are exactly perpendicular
to sides.
• The Monogram gas downdraft cooktop is
• The countertop cutout for the cooktop
The notches at the back of the cutout are:
Follow the illustration shown.
• Self-adhesive gasket • Carpenter's square
(supplied) • Pipe wrench
• Two clamping • Manual gas line
brackets and
screws (supplied) • 3/4" NPT x 3/4"
• Gas pressure
regulator (supplied)
• Large flat-blade
screwdriver
• Saw
1/4"
2-9/16"
20-11/16"
Cutout
Depth
18-1/8"
Cooktop
Cutout
Depth
3/4" Cooktop Overlap
Front Edge of Countertop
designed to fit in a 36" or larger base
cabinet.
must be:
– 34-1/2" at the front of the counter and,
– 34" at the back
– 18-1/8" front to back notch
– 20-11/16" front to back of cutout
– 2-9/16" forward and 1/4" to the inside.

Cabinetry/Ductwork

•Duct work to suit the
installation
• 1/2" NPT x 3/4"
shut-off valve I.D. or 1/2" I.D.
flare union adaptor
I.D. or 1/2" NPT x for connection to
1/2" I.D. flare regulator
union adaptor for • Gas-resistant pipe
connection to joint sealant
supply line
36"
34" Vent Cutout
34-1/2"
Cooktop Area Cutout
2-1/4" Min. Clearance to Cutout
• Allow at least 4-5/8" clearance between back
of cutout and combustible wall.
• Allow at least 8-13/16" clearance from right
and left sides of cutout to adjacent wall.
• Allow at least 2-1/4" clearance between front
of cutout and front edge of countertop.
Caution:
countertops and cabinets
should withstand 200 F heat
generated by the cooktop.
G a s Downdraf t Cooktop
• 5 foot AGA-certified
flexible metal
appliance connec-
tor, 3/4" or 1/2"
I.D. to match gas
supply line:
–If required by local
codes, use solid
pipe with fittings.
Note: Purchase new
flexible line, DO
NOT USE OLD,
PREVIOUSLY USED
FLEXIBLE LINE.
1/4"
1/4" Overlap
1/8" Gap
21-3/4"
Total Flat
Surface
Required
8-13/16" Min. Cutout
to Wall Both Sides
Wall coverings,
4-5/8" Cooktop
Cutout to
Rear Vertical
Combustible
Surface
5