Tools And Materials Required; Power Supply Locations - GE Monogram ZGU48N4G Installation Instructions Manual

Installation Preparation
TOOLS REQUIRED
• Saw
• Measuring tape
• Carpenter's square
• Large flat-blade screwdriver
• Pipe wrench
MATERIALS REQUIRED (not supplied)
• Pipe and fittings as required
• Manual gas line shut-offvalve
• Gas pressure regulator (supplied)
• Gas-resistantpipe joint sealant
• 5 foot, 5/8"AGA-certified flexible metal gas supplyline
(length must comply with local codes)
- If required by local codes, use solid pipe fittings.
NOTE:Purchase new flexible line. DO NOT USEOLD,
PREVIOUSLY USEDFLEXIBLE LINE.
POWER SUPPLY LOCATIONS
Gas Supply:
• The pressure regulator must be connected in series with the
manifold of the cooktop and must remain in series with the
supplyline regardless of the type of gas being used.
• The natural gas models are designed to operate at 5"water
column pressure. A regulator is required at the natural gas
sourceto provide a maximum of 7"water pressureto the
cooktop regulator.
• The liquid propane models are designedto operate at 10"
water column pressure. A regulator is required at the LP
source to provide a maximum of 14"water pressure to the
cooktop regulator.
• These gas cooktops are supplied with 1/2"NPT female gas
connection located at the left rear corner.
• A minimum 5/8"dia. metal flexible line is required.
- Use 5-foot long 5/8"flexible metal tubing. (Length must
comply with local codes.)
• For rigid connection, locate the pipestubwithin area shown.
• Install a manual shut-off valve in the gas line, in an easily
accessible location.
ElectricSupply:
These cooktops must be supplied with 120volt, 60 Hz., and
connected to an individual, properly grounded branch circuit
protected by a 15 amp circuit breaker or time delay fuse.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a standard
three-prong grounding wall receptacle to minimize the
possibility of shock hazard from this appliance.
If the electrical service provided does not meet the above
specifications, i t is recommendedthat a licensed electrician
install an approved outlet.
DONOT,UNDERANY CIRCUMSTANCES, CUTORREMOVE
THE THIRD(GROUND)PRONG FROMTHE POWERCORD.
DONOT USEAN EXTENSION CORDWITH THISAPPLIANCE.
• Locate the electric supplywithin the area shownor within
reach of the cooktop's six foot power cord.
• To avoid tangling cord with items storedin the cabinet, locate
the receptacle on rear wall, inside the cabinet.
7" for 36" Models
, --. 17" for 48" Models Receptacle Box Cove ___
Locate Gas Supply 2" Maximum/j
"_ Three Prong Receptacle _
Protrusion FromWall or on Floor 2" From Watt
6