Adjusting The Tear-Off Position - Epson 1170 User Manual

Off
Tear

Adjusting the tear-off position

If the paper's perforation does not meet the tear-off edge, follow
the steps below to adjust the tear-off position:
1. Make sure the paper is in the tear-off position and the TEAR
OFF light is on.
2. While holding down the ALT button, press the LOAD/EJECT
button to move the tear-off position down on the page, or
press the LF/FF button to move the tear-off position up on the
page. The printer remembers the new tear-off position even
after the printer is turned off.
3. Tear off any printed pages.
4. When you begin printing, the printer automatically feeds the
paper back to the loading position and begins printing.
Note:
The printer has a minimum and a maximum tear-off
l
position. If you try to advance the tear-off position beyond
the limits, the printer beeps and the paper stops moving.
When the paper reaches the factory-set tear-off position, the
l
printer beeps and paper feeding pauses briefly. Use the
factory setting as a reference point when you adjust the
tear-off position.
3-18 Using the Printer
-.