Using Two Tractor Units In Combination - Epson 1170 User Manual

Additional Tractor Unit

Using two tractor units in combination

Install one tractor unit in the pull-tractor position as described
1.
in Chapter 2. Install another one in the front or rear position.
2. Place the continuous paper on the sprocket units of the front
or rear push-tractor unit (see Using Continuous Paper in
Chapter 2).
3. Turn on the printer. Press the LOAD/EJECT button to load paper;
then hold down the LF/FF button to feed one page of paper.
CAUTION:
only to clear paper jams when the printer is off.
Otherwise you may damage the printer or lose the top-
of-form position.
Release the sprocket lock levers of the pull tractor and adjust
4.
the sprocket units to match the width of the paper. Be sure
that the sprocket units on both the tractors are aligned so that
the paper is not crooked.
Fit the holes of the paper over the tractor pins of the sprocket
5.
units and adjust the sprocket units as necessary (see Using
Continuous Paper in Chapter 2).
Close the sprocket covers.
6.
Using
4-14
Use the knob on the left side of the printer
Printer Options
the