interface Specifications
Note:
The column heading "Direction" refers to the direction of
l
signal flow as viewed from the printer.
"Return" denotes the twisted-pair return, to be connected at
signal ground level. For the interface wiring, be sure to use a
twisted-pair cable for each signal and to complete the
connection on the return side.
All interface conditions are based on TTL level. Both the rise
l
and fall times of each signal must be less than 0.2
microseconds.
Data transfer must be carried out by observing the ACKNLG
l
or BUSY signal. Data transfer to this printer can be carried
out only after receipt of the ACKNLG signal or when the
level of the BUSY signal is LOW.
7-12
Technical Specifications