Using Short Tear-Off
Adjusting the tear-off position
If the paper's perforation does not line up with the tear-off edge,
you can adjust the tear-off position using the micro-adjustment
feature.
1. Make sure the short tear-off feature is turned on so the printer
feeds paper to the tear-off position after printing the
document. Press and hold down the ON LINE button until the
beeper sounds once. The ON LINE light should begin blinking,
meaning you can now use the micro-adjustment feature to
make fine adjustments to the tear-off position.
: 0
CAUTION: You can only use the micro-adjustment
feature while the ON LINE light is blinking.
Using the Printer
3-17