Securing The Cabinet; Preparing To Roll Off The Pallet - HP rp7440 Service Manual

6. Remove the six bolts from the base that attaches the rack to the pallet.
Figure 3-3 Preparing to Roll Off the Pallet
WARNING!
down the ramp, and any time you roll the rack on the casters. Use caution when rolling the
cabinet off the ramp. A single server in the cabinet weighs approximately 508 lb. It is strongly
recommended that two people roll the cabinet off the pallet.
After unpacking the cabinet, examine it for damage that might have been obscured by the shipping
container. If you discover damage, document the damage with photographs and contact the
transport carrier immediately.
If the equipment has any damage, the customer must obtain a damage claim form from the
shipping representative. The customer must complete the form and return it to the shipping
representative.

Securing the Cabinet

When in position, secure and stabilize the cabinet using the leveling feet at the corners of the
base (Figure
46 Installing the Server
Be sure that the leveling feet on the rack are raised before you roll the rack
3-4). Install the anti-tip mechanisms on the bottom front and rear of the rack.