System Installation
Configuring the Management Processor for use with a Web Console
Configuring the Management Processor for use with a Web Console
The Web console is an embedded feature of the management processor (MP). The Web console allows access to
the server via the LAN port on the core I/O card. MP configuration must be done from an ASCII console.
NOTE
The MP has a separate LAN port from the system LAN port. It requires a separate LAN drop,
IP address, and networking information from that of the port used by HP-UX.
Before starting this procedure, the following information is required:
•
IP address for the MP LAN
•
Subnet mask
•
Gateway address
•
Hostname (this is used when messages are logged or printed)
To configure the LAN port for a Web console, perform the following steps:
Step 1. Type
(
b
Control-b
^
Step 2. At the MP prompt, type
Respond to each prompt with the appropriate information.
Figure 5-9 Example lc Command
72
) to access the MP LAN interface.
to access the LAN configuration command.
lc
Chapter 5