Figure 5-10 Browser Window - HP rp8400 Series Installation Manual

Installation guide, third edition - hp rp8400 server series

Hide thumbs Also See for rp8400 Series:

Table of Contents

Step 3. Access the Web console by launching a Web browser on the same subnet using the IP address for

the MP LAN port.

Figure 5-10 Browser Window

Zoom In/Out

Title Bar

Step 4. Click anywhere on the Zoom In/Out title bar to generate a full screen MP window.

There is not a separate administration layer when using the embedded Web access of the MP. When

launching the Web browser using the IP for the MP LAN port, connection is directly routed to the

MP. The Web console part of the MP employs the same users as the MP.

Step 5. Set configurable parameters.

Adding Users - The MP provides a maximum of 20 users. Only the MP administrator can add or

remove users or change the MP configuration.

To add a user, perform the following:

1. Access the MP.

2. Enter the Security Options and access control (so) command.

3. Reply appropriately to the prompts Be sure to read each prompt carefully and enter the correct

response. A missed or incorrect entry could deny entry to that user.

Chapter 5

Configuring the Management Processor for use with a Web Console

System Installation

Table of Contents