Table of Contents
Advertisement
Switching printer emulations
There are three ways to switch printer emulations: SelecType,
the Intelligent Emulation Switch (IES), and emulation control
languages.
SelecType
To choose different printer emulations for one or more of the
printer's interfaces (parallel, serial for the ActionLaser 1500
only, or optional) using SelecType, follow the instructions
below:
1. Press the LEVEL 2 button to enter SelecType Level 2. Press V
until you see the EMULATION option. Press b once.
2. Press v until you see the interface channel (P, S, or O) you
want to assign.
3.
Press ) once. Then press v until you see the emulation you
want (for example, LQ or FX).
4. Press b to set the emulation.
5.
Repeat steps 2 through 4 if you want to switch emulations in
any other channel. Then press the EXIT button to exit
SelecType.
Intelligent Emulation Switch
The Intelligent Emulation Switch is available when you install
the optional PostScript@ identity card. See Chapter 5, "Options"
for more information on identity cards.
1-24
Controlling Your Printer
Advertisement
Table of Contents
