Interface - Epson 1000 Reference Manual

INTERFACE

This Level 2 option allows you to change settings for the
built-in interfaces, parallel and serial. This option is not
available for channel 0.
Menu/submenu
The PARALLEL option has these three submenus:
Menu/submenu
Normally, you do not need to change these settings. Change
them only when you have special requirements.
SLCT-IN-When you set SLCT-IN to OFF, the printer is
continuously selected and ignores device control codes DC1
and DC3. In almost all cases, leave SLCT-IN set to OFF. When
SLCT-IN is ON, the SLCT-IN signal goes HIGH at power-on
and the control codes DC1 and DC3 are valid.
Menu/submenu
AUTOFEED-When you set AUTOFEED to OFF, the printer
ignores the AUTOFEED signal on pin 14 and does not send an
automatic line feed (LF) command with each carriage return
(CR). When you set AUTOFEED to ON, the printer adds a line
feed to each carriage return it receives. If your text lines
overprint each other, set AUTOFEED to ON.
Menu/submenu
4-14 SelecType
Available options
S (Serial) (ActionLaser 1500 only)
Available options
AUTOFEED
BUSY DELAY
Available options
OFF b ON or OFF
Available options
OFF b ON or OFF