Epson ActionLaser 1000 Product Support Bulletin

EPSON AMERICA INC.
Product Support Bulletin
Subject: New ActionLaser 1000/1500 Imaging Cartridge Replacement Procedure
Date: 6/4/93
Page(s): 1 of 2
This bulletin provides supplemental information to resolve a situation when printed
images become faint, SelecType Level 2 TONER message indicating that the
toner amount is low (E*
After the instructions to replace the imaging cartridge (as shown on pages 3-29
through 3-32 of the ActionLaser 1000/1500 Reference Guide) has been followed,
some printers may continue to display the above messages.
not affect printer operation or print quality in any way.
resetting the printer as described below:
NOTE: Resetting clears all the saved SelecType information but the status
sheet printed in step 3 shows the current settings.
1. Press the LEVEL 1 button to enter SelecType Level 1.
2. Press CONTINUE (v) button until STATUS SHEET appears on the display.
3. Press INITIALIZE / RESET (b) button twice to print a status sheet.
4. Save the status sheet for future reference, then turn off the printer.
5. Press and hold down the ON LINE, CONTINUE (v), and FEED (b) buttons
while you turn on the printer and keep pressing the buttons until the following
message appears:
When the above message appears, release the buttons.
F), and three messages flash in rotation on the LCD:
NEW CARTRIDGE?
YES, PRESS RESET
NO, PRESS CONTINUE.
STARTUP ERROR LT<>A4
PSB No: P-0100
Originator: LHT
This condition does
It can be corrected by
EPSON