Assigning An Ip Address On Windows Nt 4.0 - Epson GT-30000 User Manual

Assigning an IP Address on Windows NT 4.0

If your network is connected to the Internet, ask your Internet provider or system
administrator for a formal IP address.
If your network is not connected to the Internet, you can use an IP address in the
following ranges: 10.0.0.0 to 10.255.255.255, 172.16.0.0 to 172.31.255.255, or
192.168.0.0 to 192.168.255.255. Make sure you use a different IP address for every
computer on your network. If you are running a mixed Windows 95, Windows 98,
Windows Me, Windows 2000 and Windows NT environment, you can use an IP
address in the range of 169.254.XXX.XXX.
If you use IP addresses in the ranges listed above, you need to change
them before you connect the network to the Internet. Otherwise you'll
experience IP address conflicts.
If your network uses a DHCP server, you don't need to obtain an IP
address before beginning this procedure; the server finds one for you.
Follow the steps below to assign the IP address to your computer:
1. Select
TCP/IP Protocol
then click the
Properties
2. Click the
IP Address
screen on the right.
3. Click
Specify an IP address
your IP address and subnet mask. Click
(If you're using a DHCP server on your
network, you can assign an IP address
automatically by selecting
address from a DHCP server
clicking .)
OK
4. Click again to close the Network
OK
window and have your IP address assignment
take effect.
Make sure you share the IP address for the
scanner server with all client computers on
the network.
in the Network Protocols list on the Protocols tab, and
button.
tab to display the
, and then enter
OK
Obtain an IP
and
.
Installing the TCP/IP Protocol
127